Gridfinity USB stick bin generator
A Gridfinity bin with a slot for each USB stick, plug down. Set the plug's size, how many along and how many rows.
How to make yours
- Set the stick's thickness and width; each slot is a little bigger so it drops in.
- Set how many sticks along and how many rows; the bin grows one 42 mm square at a time to hold them.
- Set how deep each slot is, and tick on magnet holes if your baseplate has magnets.
- Download it as STL, 3MF or STEP, and print it.
What each slider does
- Plug thickness (USB-A 4.5) 2 to 12 mm
- How thick the stick's plug is.
- Plug width (USB-A 12) 6 to 30 mm
- How wide the stick's plug is.
- Sticks along 1 to 20
- How many sticks sit side by side in a row.
- Rows 1 to 3
- How many rows of pockets there are, front to back.
- Pocket depth 6 to 25 mm
- How deep each stick sits; the bin's height follows in 7 mm Gridfinity units.
- Magnet holes on or off
- Holes under each foot for magnets that hold the bin to a magnetic baseplate.
Also called
gridfinity usb holder, usb stick holder, usb drive organizer, flash drive holder, thumb drive storage, usb organizer.
Gridfinity by Zack Freedman (MIT)